We sell the problems we solve

how to maintain laser cutting machines? - automotive

by:Shihui     2020-01-23
With laser cutting machine, you can produce the most accurate and highestQuality reduction in manufacturing.In order to maintain the efficiency and consistency of these machines throughout the process, manufacturers need to carry out preventive maintenance on a regular basis.After all, the laser cutting machine is an expensive device.
The first suggestion is to avoid delay.
There is no perfection due to lack of maintenance resulting in quality degradation.To learn how laser parts work more optimally, read the steps below to keep the laser machine up to date.One of the laser materials like acrylic acid is easy to catch fire when no one is worth punctuality during cutting.
In the case of a fire, people had to replace the entire laser cutting machine.In order to eliminate this, we need to make sure that someone is always within the 3 feet range.Each manufacturer has a different type of laser cutting schedule.
Daily maintenance is one of the main things we need to ensure that the laser parts involved in the process.If you would like to replace any of them, please consider the Mazak laser part.They have good quality properties and provide a lot of cutting.
One more thing to make sure that after the cut schedule, check the lens and clean it if necessary.Because the lens and mirror at the top is right above the laser beam, it is exposed to a lot of dirt, smoke, debris and smoke.Lower speed or higher power is required to cut off.
Uneven and blurry images.
The easy way to clean the lens and mirror is to gently remove it and use q-Tip or mirror paper.You also need to maintain filters for regular maintenance tasks.Depending on its usage and material type, you need to change the internal \"padding\" pre-Filter and clean the foam dust collector.
Smoke is being collected in laser bay.
Fire/flare in the Bay.
The smell of the machine.
The filters on both sides are dirty.
Warranty is a key part of the purchase process.If you are a manufacturer and are seeking to maintain a contract or extend the warranty, the purchasing department must have a comprehensive understanding of the points covered therein.Does the contract include maintenance and parts?If so, then does it cover laser parts that are better than laser parts?Is there a discount on any parts that need to be replaced?Without a contract, how much is the emergency service call going to cost?What are the possible limitations of the contract?With cutting, plastic, it is possible to produce a smell.
However, beforeFiler removes particle matter most effectively.But power companies also have 20-pound carbon particles.They absorb the bad smell.In the end, the charcoal will become \"full\" and will not absorb the smoke.
The smell of burning plastic is very strong.The smoke was sucked away.The filter is clean but the problem is not gone.Charcoal smells of smoke.To replace the charcoal, pour out the old charcoal and throw it away.
Pour in cup-Fill the fashion with fresh charcoal with rubber materials or wooden piles to wrap the charcoal.The maintenance of laser parts varies depending on their use and type.No one-size-fits-Correctly maintain all solutions for the laser manufacturing process.
When you replace the laser part, if you write a query such as \"trumpf laser parts\" and \"mazak laser parts\", you can find several options from the Internet.Maintaining lessons learned has resulted in more consistent, reliable and economical resultsEffective Laser operation
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...